surlyville

9 ms·

1.
by surlyville 1y ago
Same here. Still rocking a DS415+ from 2015. Had to solder a 100ohm resistor to work around the Intel Atom C2000 flaw. Has had a new set of spinning rust in that time too. It's also connected to UPS so will power down if there's a
2.
by surlyville 2y ago
Jailbreak not required. I use TrollStore/TrollDecrypt but I'm sure there are other methods.
3.
by surlyville 2y ago
Yes, the motor is running but I'm sure the chain does stop spinning. Surely your finger comes off the throttle when it's not actually cutting, i.e. there must be some up and down action involved even if someone else is positioning
4.
by surlyville 2y ago
As an arborist I use both battery and petrol saws professionally. The top handled battery saws do have their place. Perfect when the tree pruning/removal involves many smaller cuts (< 6" or 150mm) My main reasons for using the
5.
by surlyville 2y ago
I can assure you that the chainsaw is not running continuously when you're cutting firewood. Yes, the engine might be running but your finger is not on the throttle hence it's idling.
6.
by surlyville 3y ago
Exactly. Family of iPhone 6-8 here too running ios 14.7.1-16.7. Spent $100 on a new battery.
7.
by surlyville 3y ago
UTM works much better if you can install the Hypervisor version via TrollStore. Unfortunately you can't do that with M2 iPads since they came with iOS 16.1 from factory and TrollStore only works on iOS 15.0-15.4.1 Luckily I have an M1
8.
by surlyville 3y ago
Try CB Defense for 20 seconds of lag instead
9.
by surlyville 8y ago
For almost 11 years I worked professionally with Delphi (2-6) before retiring from programming completely in 2006. Then in 2019 I'm back modifying some Delphi programs (microservices against Oracle DB) that I wrote over 15 years ago...